JUKI AMS-210DHL - Catalog and Manual (EN)

Для проверки артикула сверяйтесь с оригинальной схемой.

@® By adopting the hot-wire heater, thick thread can be easily cut.
@ Thread trimming time can be optionally set in accordance with the thread count.
(Start of heating the hot-wire can be performed during sewing or after completion of sewing by optional
external output setting.)
@ Thread is cut by fusing, and it is effective to prevent thread from fraying.
@ Bird’s nest at the start of sewing can be reduced since the needle thread remaining on the needle is shorter.
(Needle thread remaining at the start of sewing can be reduced since thread is hard to come out from the
needle eyelet because of the needle thread resulted in a ball by fusing.)
® The amount of thread remaining on the needle at the end of sewing is reduced by less than 1/2 as compared
with our moving knife type thread trimmer.
(The after-treatment process of remaining thread is not necessary.)
© Respective thread trimming drive timings can be optionally set by the external input/output.
(Standard setting example * Bobbin thread trimming — needle thread feeding — needle thread trimming)
: Amount of remaining needle/bobbin threads is small.
(Optional setting example I » Needle thread feeding — needle thread trimming — bobbin thread trimming)
: Amount of remaining bobbin thread only is secured.
(Optional setting example II + Needle thread feeding — simultaneous thread trimming of needle/bobbin
threads)
: Thread trimming time to cut thread is shorter than that of the optional setting example I.
(Optional setting example I * Bobbin thread trimming — needle thread feeding)
: Bobbin thread only is cut.
@ The hot-wire guide can prevent sewing material from being fused.
(The direct contact of the hot-wire with the material can be avoided by securing the interval between upper
surface of material and the hot-wire.)
Both the conventional moving knife type thread trimmer and this one can be used.
(The standard throat plate asm. and standard wiper set can be replaced.)
@ Working property in sewing operation is improved since the whole hot-wire device is miniaturized by
approximately 1/2 as compared with the conventional one.