JUKI FU-05

Для проверки артикула сверяйтесь с оригинальной схемой.

10. REO SYA ORME / CONTROLLING THE INVERTING CLAMP
RRISYoORD
Center of inverting
clamp
oe |, #13 mm
| “PPIs 13mm
Y
u
* RA Uk (Hea — | No,005: S oe
aes Be
aOR,
REIDY GIs, AGI BRET
aa. TSS
RI 2D EEIK Bai
1) LMS
DR
—Y (RETO) (o— L)
an reten,
—YUYSIEEO
The inverting crank is actuated between A and & sides by the air cylinder. When automatic inversion @ is selecied
with clamp inversion setting (function code No, 091 : refer ta IP-400 INPUT INSTRUCTION MANUAL), the inverting
crank siatus is controlled as described below.
1) When 4 pattern (pattern with an inversion) is read from a floppy disk and the origin is retrieved, the inverting
crank is inverted to A side.
2)
When the start switch is turned on at the sewing starting point or the 2nd origin (already established in the
pattern by the input device), the inverting crank is also inverted to A side. (Nothing is output when operating the
forward key.)
3) When the needle passes the line 2 located approximately 13 mm.
% below the center of the inverting crank that is also contained in the right-hand side portion of Y-axis, the
inverting crank will be inverted to B side when the sewing proceeds in direction @ or A side when the sewing
proceeds in direction b.
4) When the sewing siarting point or 2nd origin is retrieved after the completion of sewing, the inverting crank is
inverted to A side.
3¢ In the case where an inverting point (function code No. 005: refer to IP-400 INPUT INSTRUCTION MANUAL.)
not performed.
(REGAN LOROD TE)
MODMRBEICLT, RE
FOC SEU
IPA OULD
[Dimensions for machining an inverting
intermediate presser]
Machine the inverting intermediate presser referring
to dimensions given In the illustration.
GER)
NOUS. DIO SAIC KO CRAPS
REID U IPDS COBRU RRO clues
LTC.
(Caution)
When creating a sewing pattern, note that the
distance from the origin to the center of inverting
clamp varies according to the sub-class machines.
is set when inputting a sewing pattem, the inverting crank will be inverted from A to B or’B to A at the
specified point. At this time, the inversion ai line | located 13 mm below the center of the inverting crank is
(REI SVIbD)
(Center of inverting
crank}
(RE RIRA RAT)
{Inverting intermediate
30
14t045 L | (50) presser base)
24
—— 0 (RHR)
(Machanica origin)
| 2% AMS-210E-1308 + 2206 j& 3Omm,
AMS-210E-1510-22101¢50mm GF.
3% AMS-210E-1306 and 2206 : 30 mm
AMS-210E-1510 and 2210 ; 30 mm
1
—12-