JUKI AT-8

Для проверки артикула сверяйтесь с оригинальной схемой.

Install the solenoid magnet @ in the cutter mounting base so
that the plunger of the magnet has a stroke of 20 mm by positioning
the double lock nuts @ and, at the same time, insert the end of
the plunger @ into the upper hole on the driving shaft bearing
@ .
Attach the counter plate gs) to the special throat plate for
the tape cutting device and install them to the machine bed.
Install the knife mounting base under the knife driving shaft ©
and attach the upper knife @ . Align the knife in parallel and
tighten the knife connection ® so that the knife connection guide
does not have any play.
Put the electric cord into the guide groove and install the
cover . Attach the micro switch 4 to the bottom of the cutter
mounting base, pass the cord through the hole (A) and fasten it by
the cord holder @ together with the cord from the solenoid
magnet. Fix the bundled cords to the rear of the machine by means
of another cord holder @ and the screw (B) and then bring them
towards the rear face of the machine table.
Installing the knife.
Install the knife with its sharpened side facing to the operator
and with care that the blade is accurately positioned in parallel
with the mating surface of the counter plate @® .
Attach the knife cover @3 .